Package "linux-riscv-6.17"

 linux-riscv-6.17 (6.17.0-9.9.1~24.04.1) noble; urgency=medium
 .
   * noble/linux-riscv-6.17: 6.17.0-9.9.1~24.04.1 -proposed tracker (LP: #2133507)
 .
   * Enable Nezha board (LP: #1975592)
     - SAUCE: mmc: pwrseq_simple: always fall back to GPIO based reset control
     - SAUCE: nvmem: core: update cell->bytes after shifting bits
     - SAUCE: dt-bindings: pwm: Add binding for Allwinner D1/T113-S3/R329 PWM
       controller
     - SAUCE: pwm: Add Allwinner's D1/T113-S3/R329 SoCs PWM support
     - SAUCE: riscv: dts: allwinner: d1: Add pwm node
     - SAUCE: riscv: dts: allwinner: d1: Add PWM pins
     - SAUCE: mmc: sunxi-mmc: Correct the maximum segment size
     - SAUCE: riscv: dts: allwinner: d1: Add misc nodes
     - SAUCE: riscv: dts: allwinner: Keep aldo regulator on
     - SAUCE: riscv: dts: allwinner: Add button on the Nezha board
     - SAUCE: riscv: dts: allwinner: Add button on the Lichee RV Dock
     - SAUCE: regulator: dt-bindings: Add Allwinner D1 LDOs
     - SAUCE: regulator: sun20i: Add support for Allwinner D1 analog LDOs
     - SAUCE: regulator: sun20i: Use device_node_to_regmap()
     - SAUCE: dt-bindings: thermal: sun8i: Add compatible for D1
     - SAUCE: thermal: sun8i: Set the event type for new samples
     - SAUCE: thermal: sun8i: Ensure vref is powered
     - SAUCE: riscv: dts: allwinner: d1: Add thermal sensor and zone
     - SAUCE: riscv: dts: allwinner: d1: Hook up PWM-controlled CPU voltage
       regulators
     - SAUCE: drm/sun4i: dsi: Allow panel attach before card registration
     - SAUCE: drm/sun4i: mixer: Remove unused CMA headers
     - SAUCE: drm/sun4i: tcon: Always protect the LCD dotclock rate
     - SAUCE: drm/sun4i: tcon_top: Register reset, clock gates in probe
     - SAUCE: riscv: dts: allwinner: lichee-rv-86-panel-480p: Add panel
     - SAUCE: riscv: dts: allwinner: d1: Add HDMI pipeline
     - SAUCE: riscv: dts: allwinner: d1: Enable HDMI on supported boards
     - SAUCE: dt-bindings: display: sun4i-tcon: Add external LVDS PHY
     - SAUCE: riscv: dts: allwinner: d1: Add LVDS0 PHY
     - SAUCE: riscv: dts: allwinner: d1: Add LED controller node
     - SAUCE: riscv: dts: allwinner: d1: Add RGB LEDs to boards
     - SAUCE: ASoC: sun20i-codec: New driver for D1 internal codec
     - SAUCE: [WIP] ASoC: sun20i-codec: What is this ramp thing?
     - SAUCE: riscv: dts: allwinner: d1: Add sound cards to boards
     - SAUCE: dt-bindings: display: sun8i-a83t-dw-hdmi: Remove #phy-cells
     - SAUCE: dt-bindings: display: Add D1 HDMI compatibles
     - SAUCE: drm/sun4i: Add support for D1 HDMI
     - SAUCE: drm/sun4i: sun8i-hdmi-phy: Add support for D1 PHY
     - SAUCE: [HACK] drm/sun4i: Copy in BSP code for D1 HDMI PHY
     - SAUCE: riscv: dts: allwinner: Add Nezha and Lichee RV SPI nodes
     - SAUCE: dt-bindings: display: Add Sitronix ST7701s panel binding
     - SAUCE: drm/panel: Add driver for ST7701s DPI LCD panel
     - [Config] riscv: updateconfigs for D1 support
 .
   * Enable StarFive VisionFive 2 board (LP: #2013232)
     - SAUCE: PCI: starfive: Offload the NVMe timeout workaround to host
       drivers.
     - SAUCE: pwm: opencores: Add PWM driver support
     - riscv: dts: starfive: jh7110-common: drop no-sdio property from mmc1
     - dt-bindings: memory-controllers: add StarFive JH7110 SoC DMC
     - riscv: dts: starfive: jh7110: add DMC memory controller
     - riscv: dts: starfive: jh7110: bootph-pre-ram hinting needed by boot
       loader
     - riscv: dts: starfive: jh7110-common: drop no-mmc property from mmc1
     - riscv: dts: starfive: jh7110-common: drop mmc post-power-on-delay-ms
     - riscv: dts: starfive: add common board dtsi for Milk-V Mars CM variants
     - dt-bindings: riscv: starfive: add milkv,marscm-emmc
     - riscv: dts: starfive: add Milk-V Mars CM system-on-module
     - dt-bindings: riscv: starfive: add milkv,marscm-lite
     - riscv: dts: starfive: add Milk-V Mars CM Lite system-on-module
     - SAUCE: dts: starfive: jh7110-common: split out mmc0 reset pins from
       common into boards
     - SAUCE: dt-bindings: riscv: Add StarFive JH7110S SoC and VisionFive 2
       Lite board
     - SAUCE: riscv: dts: starfive: jh7110-common: Move out some nodes to the
       board dts
     - SAUCE: riscv: dts: starfive: Add common board dtsi for VisionFive 2 Lite
       variants
     - SAUCE: riscv: dts: starfive: Add VisionFive 2 Lite board device tree
     - SAUCE: riscv: dts: starfive: Add VisionFive 2 Lite eMMC board device
       tree
     - SAUCE: dt-bindings: riscv: starfive: add xunlong,orangepi-rv
     - SAUCE: riscv: dts: starfive: add Orange Pi RV
     - [Config] riscv: updateconfigs for JH7110 support
 .
   * Miscellaneous Ubuntu changes
     - SAUCE: tools/lib/perf: Fix -Werror=alloc-size-larger-than in cpumap.c
     - [Config] Enable pre-RVA23 hardware