Package "linux-qcom"

  linux-qcom (6.8.0-1055.55) noble; urgency=medium

  * noble/linux-qcom: 6.8.0-1055.55 -proposed tracker (LP: #2123917)

  * Bringing up RPI IMX577 in RB4
    - ARM: dts: msm: Camera: Add dtsi for RB4 4xPMIC dev
    - ARM: msm: dts: camera: Add support for RPi imx577 sensor
    - SAUCE: dts: qcom: add 2 qcs8275 platforms in the makefile

  * [RB8] 0004-QCLINUX-net-stmmac-Add-EEPROM-support-to-driver.patch feedback
    - Revert "QCLINUX: net: stmmac: Add EEPROM support to driver"

  * [RB8] FAN inverted PWN handling
    - hwmon: (amc6821) Add PWM polarity configuration with OF
    - SAUCE: dts: qcom: add pwm polarity for fan

  * [QC] Using mbn instead of mdt
    - arm64: dts: qcom: switch from .mdt to .mbn firmwares

  * RB4 Audio BU with TPLG support
    - RB4: support tplg based soundcard

  * Miscellaneous upstream changes
    - arm64: dts: rubikpi: add RUBIK Pi related basic device tree
    - arm64: dts: rubikpi: compatible with USB-A 2.0 port
    - arm64: dts: rubikpi: enable USB3.0 HUB
    - arm64: dts: rubikpi: enable M.2 port
    - net: ax88179b: add driver
    - arm64: dts: rubikpi: enable fan
    - arm64: defconfig: enable ax88179b config
    - wifi: ap6256: add driver
    - arm64: dts: rubikpi: enable Wi-Fi
    - arm64: dts: rubikpi3: enable bluetooth
    - serial: qcom-geni: increase uart ports to 13
    - arm64: dts: rubikpi: enable rtc to support time writing
    - arm64: dts: rubikpi: camera: bringup imx219 and imx477
    - drm/bridge: lt9611: rubikpi: enable hdmi out
    - arm64: dts: rubikpi3: enable hdmi out interface
    - ASoC: es8316: rubikpi: enable 3.5mm headphone jack
    - arm64: dts: rubikpi3: enable 3.5mm headphone jack
    - spi: spidev: add an entry for thundercomm,rubikpi
    - arm64: dts: rubikpi: enable bus interface on 40 pin
    - ASoC: qcom: qcm6490: rubikpi: enable HDMI OUT audio
    - arm64: dts: rubikpi3: enable HDMI OUT audio
    - arm64: dts: rubikpi3: Enable Bluetooth kernel driver
    - drm/bridge: lt9611: rubikpi: fix the problem of hot plug failure
    - arm64: dts: rubikpi3: modify the interrupt trigger mode of HDMI out
    - arm64: dts: rubikpi: camera: Remove unnecessary gpio controls
    - Ubuntu: [Config] update CONFIG options for Rubik Pi 3
    - drm/bridge: lt9611: rubikpi: fix some HDMI monitors cannot display
    - arm64: dts: rubikpi3: added min-vblank configuration for hdmi function
    - HID: multitouch: Add support for QinHeng Electronics USB2IIC_CTP_CONTROL
    - soc: qcom: pmic_glink: resolve compilation errors
    - arm64: dts: rubikpi3: Increase temperature trigger point
    - arm64: dts: rubikpi3: Enable USB Type-C display
    - arm64: dts: rubikpi3: change device tree name
    - arm64: dts: rubikpi3: set the Bluetooth serial port baud rate to 3Mbps
    - arm64: dts: rubikpi3: remove pm7325b
    - ASoC: qcom: qdsp6: q6apm: add S32_LE format support for hw playback
    - ASoC: qcom: qcm6490: roll back qcm6490.c to its original state
    - ASoC: qcom: qcm6490: rubikpi: add support for RubikPi3 board
    - ASoC: codecs: es8316: enable MCLK
    - arm64: dts: rubikpi3: modify dtsi to enable kernel ALSA PCM
    - arm64: dts: rubikpi3: switch the USB2.0 Type-A port to OTG mode
    - ASoC: codecs: es8316: roll back the es8316 driver to its original state
    - ASoC: codecs: es8316: modify the es8316 driver to adapt to RubikPi3
    - arm64: dts: rubikpi3: modify the es8316 power supply pin
    - wifi: ap6256: disable configuration file hash detection
    - drm/bridge: lt9611: roll back the lt9611 driver to its original state
    - drm/bridge: lt9611: modify the lt9611 driver to adapt to RubikPi3
    - arm64: dts: rubikpi3: adjust the register configuration of LT9611
    - Ubuntu: [Config] Disable bcmdhd wifi driver

 -- Hui Wang <email address hidden> Tue, 16 Sep 2025 19:54:50 +0800

  linux-qcom (6.8.0-1054.54) noble; urgency=medium

  * noble/linux-qcom: 6.8.0-1054.54 -proposed tracker (LP: #2122312)

  * [RB8][x03] bam-dma-engine errors found in dmesg (LP: #2109950)
    - PENDING: arm64: dts: qcom: Add num-channels and num-ees for bam-dma

  * [qcom] Fix bug regarding DT qcom,phy-rst-gpio property (LP: #2120806)
    - QCLINUX: data-eth: qps615: Add fallback for PHY reset GPIO using
      alternate property

  * [qcom] real solution for thermal_sys failed to bind errors
    - QCLINUX: arm64: dts: qcom: Update cooling cell for cdsp node for qcm6490
    - QCLINUX: arm64: dts: qcom: Update cooling cell for msm_gpu node for
      qcm6490

  * camera-UAPI headers not packed as part of dev package
    - [Packaging] add usr/include/camera_kt/*.h files to linux-libc-dev-qcom

  * [RB8][x04] USB storage via type-c port not detected on second plug-in
    - Revert "usb: xhci: Implement xhci_handshake_check_state() helper"

 -- Hui Wang <email address hidden> Mon, 08 Sep 2025 18:21:17 +0800

  linux-qcom (6.8.0-1051.51) noble; urgency=medium

  * noble/linux-qcom: 6.8.0-1051.51 -proposed tracker (LP: #2117724)

  * [RB3][x04] alsa playback/record test failed
    - ASoC: qcom: qdsp6: q6apm: fix capture pipeline overruns

 -- Masahiro Yamada <email address hidden> Wed, 23 Jul 2025 23:29:48 +0900

  linux-qcom (6.8.0-1050.50) noble; urgency=medium

  * noble/linux-qcom: 6.8.0-1050.50 -proposed tracker (LP: #2116573)

  * Incorrect graphics dtbo file used in case of qcs5430-fp(2p5|3)-addons-
    rb3gen2-vision-mezz-ovl.dtb
    - SAUCE: fix graphics DTBO for qcs5430-{fp2p5,fp3}-addons-rb3gen2-vision-
      mezz

  * [linux-libc-dev-qcom] Requires smcinvoke.h for securemsm build
    - SAUCE: include linux/smcinvoke.h in linux-libc-dev-qcom package

  * [QC] Kernel crash from libgbm - followup
    - QCLINUX: iommu/arm-smmu: qcom: Fix arm_smmu_domain usage in fault
      handler

 -- Masahiro Yamada <email address hidden> Fri, 11 Jul 2025 20:30:43 +0900

  linux-qcom (6.8.0-1048.48) noble; urgency=medium

  * noble/linux-qcom: 6.8.0-1048.48 -proposed tracker (LP: #2116048)

  * INVALID or PRIVATE BUG (LP: #2115967)
    - SAUCE: camera_kt: fix double locking in cleanup function

  * CONFIG_MMAP_MIN_ADDR should 32768
    - UBUNTU [Config] set CONFIG_DEFAULT_MMAP_MIN_ADDR=32768

 -- Masahiro Yamada <email address hidden> Mon, 07 Jul 2025 17:13:59 +0900